How To Replace Tail Lights For Your Nissan

  1. Safety First: Gather Your Tools and Materials

Before you begin replacing your Nissan’s tail lights, it’s essential to prioritize safety. Ensure you have the necessary tools and materials ready:

  • Replacement tail light assembly
  • Screwdriver set
  • Gloves
  • Safety glasses
  • Jack and jack stands (if required)
  • Wrench set
  • New bulbs (if not included with the assembly)
  1. Locate the Tail Light Assembly

The first step in replacing your Nissan’s tail lights is to locate the tail light assembly on the rear of your vehicle. This may vary depending on your Nissan model, but generally, the tail light assembly is accessible from inside the trunk or by removing the rear panel from the outside.

  1. Remove the Old Tail Light Assembly

To remove the old tail light assembly, follow these steps:

  • If accessing the assembly from inside the trunk, remove any trunk liner or covers that may be obstructing access.
  • Locate the screws or bolts securing the tail light assembly in place.
  • Use a screwdriver or wrench set to carefully remove the screws or bolts. Be sure to place them in a safe location for reinstallation.
  • Gently pull the tail light assembly away from the vehicle. If it’s stuck, you may need to use a plastic trim tool to pry it loose.
  1. Disconnect Wiring and Bulbs

Once you’ve removed the tail light assembly, you’ll need to disconnect the wiring harness and bulbs:

  • Identify the wiring harness connected to the back of the tail light assembly.
  • Carefully disconnect the wiring harness by pressing any release tabs or connectors.
  • If you’re replacing bulbs separately, twist the bulb sockets counterclockwise to remove them from the assembly.
  1. Prepare the New Tail Light Assembly

Before installing the new tail light assembly, it’s a good practice to inspect it and make sure it’s the correct replacement for your Nissan model. Additionally, if your new assembly doesn’t come with bulbs, transfer the bulbs from the old assembly to the new one.

  1. Install the New Tail Light Assembly

To install the new tail light assembly, follow these steps:

  • Connect any bulbs to the new assembly if they were not pre-installed.
  • Reconnect the wiring harness to the back of the assembly, ensuring it clicks securely into place.
  • Position the new tail light assembly in place, aligning it with the screw or bolt holes.
  • Use the screws or bolts you removed earlier to secure the assembly to the vehicle. Tighten them snugly, but avoid over-tightening to prevent damage.
  1. Test the New Tail Lights

After you’ve installed the new tail light assembly, it’s crucial to test the lights to ensure they work correctly. Have someone assist you by pressing the brake pedal and engaging the turn signals while you observe the new tail lights to confirm they function as expected.

  1. Reassemble Any Removed Components

If you had to remove trunk liners or rear panels to access the tail light assembly, reassemble them carefully, ensuring they are securely in place.

  1. Final Check and Adjustment

Before concluding the replacement process, make a final check of the tail lights to ensure they are aligned correctly and securely attached. Adjust them if necessary to ensure they are level and properly seated.

Enjoy Safe and Functional Tail Lights

Replacing your Nissan’s tail lights is a manageable DIY task that can help maintain your vehicle’s safety and appearance. By following these steps and taking the necessary safety precautions, you can enjoy safe and functional tail lights on your Nissan, enhancing your visibility on the road and ensuring compliance with traffic regulations.